TeamViewer Forum

General Category => Teamviewer for Windows => Topic started by: dexterdoo on August 25, 2014, 09:41:57 AM

Title: Unattended Access
Post by: dexterdoo on August 25, 2014, 09:41:57 AM

I've installed TV with unattended access on my brother's computer and it shows in my contact list. But every time his computer is rebooted I have to call and tell him to activate TV before I can access it again. We both are using Windows 7. I don't have this problem with any other remote computer.  Any ideas?  ???  Thanks!

Title: Re: Unattended Access
Post by: dexterdoo on August 25, 2014, 05:44:50 PM

CORRECTION:

Actually when I rebooted, TV does return to my contact list. But after a few hours it disappears even though there's been no change of the remote computer's status!???

Title: Re: Unattended Access
Post by: Danl on August 31, 2014, 10:16:28 AM

That's really simple. The preferences in TV allow you to specify that TV gets automatically started when the system is rebooted. That's a big help with remote computers that suffeer power failures and automatically reboot when they do. In Preferences > General - check "Start TV With System" on your brother's computer. Not sure why it would disappear from your contact list, though.