TeamViewer Forum

General Category => Teamviewer for Windows => Topic started by: mritorto on October 16, 2014, 10:07:28 AM

Title: The screen cannot be captured at the moment remote desktop to windows 2008 serve
Post by: mritorto on October 16, 2014, 10:07:28 AM

hi everyone

I used remote desktop to install teamviewer 9 on my windows 2008 r2 server.

I installed it for unattend access and the teamviewer service is running but when I try to connect to the server using teamviewer

I get this message

But now I get a message "The screen cannot be captured at the moment. This  ...
...  switching or a disconnected/minimized Remote Desktop session


when I log off the server with remote desktop and I try to connect using teamviewer I get the message that the teamviewer is not running.

I installed the full version on the server too.

I can't seem to find any answer to this on the internet please help me!!!

Title: Re: The screen cannot be captured at the moment remote desktop to windows 2008 serve
Post by: matt on October 16, 2014, 06:34:12 PM

Did you install from a console session?

Title: Re: The screen cannot be captured at the moment remote desktop to windows 2008 serve
Post by: mritorto on October 17, 2014, 06:09:30 AM

no I did the install remotely over a vpn using remote desktop.

Title: Re: The screen cannot be captured at the moment remote desktop to windows 2008 serve
Post by: matt on October 17, 2014, 11:58:53 PM

Then try again from a console session please

Title: Re: The screen cannot be captured at the moment remote desktop to windows 2008 serve
Post by: mritorto on January 07, 2015, 08:37:58 AM

I haven't been able to physically install teamview on a windows 2008 server.

Can you new version 10 run with out an issue